Drafting table desk – First, open a folding table legs kit. 18 -tamers Slide a piece of PVC pipe in the lower ends. Place the leg assembly on the floor and push the PVC all the way up the legs until you reach the curve. Drive 3 of the 1.5 inch screws evenly distributed along the length of PVC pipe, where the metal pins are inserted. Second place the 36-by -42- inch plywood on a flat surface. . Plywood must be placed so that it runs 42 inches from left to right, and 36 inches away from you. Measure 8 inches from each corner along the 36-inch edges. Mark each 8-inch measurement with a pencil.
Third steps to make drafting table desk, place the adjustable legs kit with PVC legs attached, so it is closest to the top edge, or the edge farthest from you. Cover the upper connection on the legs with the two 8-inch marks. Run a 3/4-inch screw through each hole in the leg mounts. Fourth, place the adjustable arms on the side of the table, and then run a 3/4-inch screw through each hole in the adjustable arms.
12 Photos Gallery of: Make a Creative Drafting Table Desk
Fiveth, rrepeat steps 3 and 4 of the second adjustable legs kit, so that the leg associated with PVC is the closest to the back edge, which runs parallel to the first leg. Using a drill for securing the both sets of legs. Sixth, place the drawing board with the higher leg in the back and shorter leg closest to you. The drafting table desk will stand at an angle, so architects to prepare with ease. 7th Cover the entire top side of the plywood with rubber cements, and then rolls on vice sheets.